This was the largest grip that could be formed from the old stock blanks. They were not deep enough to get the full pistol grip of the Type C (modified) stock that had been standardized in 1929, so the drawing was modified to allow a "scant" grip to be used. There were already many thousands of stock blanks on hand that were sized for the old straight stock. The "scant" stock came about in late 1941 when the Ordnance wanted to standardize on a pistol-grip stock for all M1903 rifles. THE PART HAD TO HAVE BEEN IN EXISTENCE WHEN THE ITEM WAS ASSEMBLED.
#1903a3 stock crack serial number
IF YOUR ITEM HAS A SERIAL NUMBER CLOSE TO WHERE THE PART WAS CHANGED, USING THE EARLIER VERSION WILL ALWAYS BE RIGHT.
HERE IS A RULE TO FOLLOW WHEN RESTORING ANY ITEM WITH A SERIAL NUMBER, AND IT REQUIRES PARTS WHICH WERE REVISED AT A PARTICULAR SERIAL NUMBER RANGE: IF ANYONE CAN PROVIDE BETTER INFORMATION, PLEASE SEND IT. tHE NUMBERS WITH QUESTION MARKS AFTER THEM ARE ESTIMATES. THERE ARE SOME DIFFERENCES BETWEEN THE 3, AND 1 OF THEM MAY BE HALF FACT, HALF FICTION. I will list the main stamps by manufacturer in sequence of use, plus other stamps put on. The circled 'P' went on the pistol grip halfway between the trigger guard and bottom. The maker's mark and Ordnance wheel went on the center side of the stock below the back end of the receiver.
Fired with proof round and checked for damage The stamps were put on the rifles to show that 3 things had been done:Ģ.
0 kommentar(er)
